LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2020 (Interior Lighting System) >> Removal And Installation >> Ambient Lighting Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the storage compartment door.
  2. Remove the floor console finish panel.
    • Pull up on the rear of the floor console finish panel to release the clips.
    • Disconnect the electrical connector.
  3. Disconnect the ambient lighting switch electrical connector.
  4. Squeeze the retaining tabs and remove the ambient lighting switch.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals