LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2017 (HVAC - Climate Control System) >> Removal And Installation >> Blower Motor Speed Control >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Detach the glove compartment damper from the glove compartment.
  2. Remove the glove compartment.
  3. Disconnect the blower motor speed control electrical connector.
  4. Remove the 2 blower motor speed control screws.
  5. Remove the blower motor speed control.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals