Window Glass - Rear Quarter: Removal
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the C-pillar, D-pillar and rear quarter trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- From inside the vehicle, using the Deluxe Windshield Removal Tool, begin cutting the urethane adhesive starting at the upper C-pillar and work down, across the D-pillar, then across the bottom.
- Remove the rear quarter window glass.
WARNING:
Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
WARNING:
Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this instruction may result in serious personal injury.
NOTE:
To avoid rust formation, use extreme care not to scratch the paint or primer, or otherwise damage the pinch weld during glass removal.
NOTE:
Insert the blade into the Deluxe Windshield Removal Tool so that the flat side is against the glass. This will leave the entire urethane adhesive bead on the pinch weld and allow a dry fit of the replacement quarter glass.
NOTE:
Lubricate the existing urethane adhesive with water to aid the Deluxe Windshield Removal Tool while cutting.