Glass Reseal - Rear: Material
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATION
| Item | Specification |
|---|---|
| Dow Urethane Adhesive Betaseal™ Express |
- |
| Sika Urethane Adhesive Sika Tack ASAP |
- |
| Ultra-Clear Spray Glass Cleaner ZC-23 |
ESR-M14P5-A |
- Remove the rear window wiper motor. For additional information, refer to WIPERS AND WASHERS .
- Clean the interior and exterior of the rear window glass surface with glass cleaner.
- Cut the urethane adhesive applicator tip to specification.
- Apply the urethane adhesive over the top of the existing urethane adhesive from the interior of the vehicle.
- After the urethane adhesive cures, check the rear glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as necessary.
- Install the rear window wiper motor. For additional information, refer to WIPERS AND WASHERS .
NOTE:
Use either a high ratio, electric or battery-operated caulk gun that applies the urethane adhesive with less effort and continuous bead.
NOTE:
Make sure that all gaps in the urethane adhesive are smoothed into one continuous bead.
NOTE:
The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.