LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2016 (Windows And Glass - Glass, Frames And Mechanisms) >> Diagnosis And Testing >> Glass, Frames and Mechanisms >> Pinpoint Tests >> Pinpoint Test D: A Single Power Window is Inoperative - LH Front, Edge >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The LH front window control switch receives power from the accessory delay relay through circuit CBP41 (BU). The LH window motor receives battery power through circuit SBP04 (GN/RD) and ground through circuit GD133 (BK). When the LH front window control switch is pulled, the LH front window motor receives a voltage signal through circuit CPW11 (BU/GY) which causes the window to move upward. When the LH front window control switch is pressed, the LH front window motor receives a voltage signal through circuit CPW10 (YE/VT) which causes the window to move downward. When the LH front window control switch is pressed or pulled to the second detent position (AUTO), the LH front window motor receives a ground signal on circuit CPW29 (VT/GY) which causes the LH front window motor to enter one-touch up/down mode.

This pinpoint test is intended to diagnose the following: