Glass, Frames and Mechanisms: Notes
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
The glass, frames and mechanisms consist of the following:
- Accessory delay relay
- Door window regulator motors
- Front door glass top run
- Front door window glass
- HVAC module
- Liftgate window glass
- Rear door glass top run
- Rear door window glass
- Rear fixed window glass
- Rear quarter glass
- Rear window defrost grid
- Rear window defrost relay
- Rear window regulator and motor - run and brackets
- Smart Junction Box (SJB)
- Window control switches
- Window regulators
- Windshield glass
The glass, frames and mechanisms include the following:
Edge
- Standard power windows, which include one-touch up and one-touch down (LH front window only)
- Lock-out feature, when the LH front window lock switch is in the LOCK position, the passenger windows will only operate from the LH front window control switch
MKX
- Standard power windows, which include one-touch up and one-touch down (LH and RH front windows only)
- Lock-out feature, when the LH front window lock switch is in the LOCK position, the rear passenger windows will only operate from the LH front window control switch
All vehicles
- Liftgate glass which includes the rear window defrost grid and rear wiper arm
- Standard plastic and laminate safety glass
- Windshield glass which is bonded to the opening flange with a urethane adhesive
The window regulator control switch:
- is located on each door trim panel.
- may be used to manually raise or lower all windows from the left front window control switch or the individual side window from the corresponding individual door switch.
- can manually lower/raise the LH side window (and RH front window on MKX) when the corresponding front window control switch is pressed/pulled and held in the first detent position.
- can automatically lower/raise the driver side window (and right front window on MKX) when the corresponding front window control switch is momentarily pressed/pulled to the second detent position and released.