Instrument Cluster (IC) DTC Chart
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
INSTRUMENT CLUSTER (IC) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1213 | Anti-Theft Number of Programmed Keys is Below Minimum | If DTC B1600, B1601, B1602, B1681 or B2103 is present, they must be addressed first. If DTC B1213 is the only DTC present, PROGRAM additional keys. REFER to INTEGRATED KEYHEAD TRANSMITTER (IKT) KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT . CLEAR the DTCs. CYCLE the ignition. REPEAT the self-test. |
| B1600 | PATS Ignition Key Transponder Signal is Not Received | GO to PINPOINT TEST B . |
| B1601 | PATS Received Incorrect Key-Code From Ignition Key Transponder | GO to PINPOINT TEST C . |
| B1602 | PATS Received Invalid Format of Key-Code From Ignition Key Transponder | GO to PINPOINT TEST D . |
| B1681 | PATS Transceiver Module Signal is Not Received | GO to PINPOINT TEST E . |
| B2103 | Antenna Not Connected | GO to PINPOINT TEST A . |
| B2141 | NVM Configuration Failure | There is no PCM ID stored in the IC . CARRY OUT a parameter reset of the IC and PCM, then CYCLE the ignition and make an attempt to start the vehicle. REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET . |
| B2431 | Transponder Programming Failed | The ignition key was not programmed. ATTEMPT to program the key. REFER to INTEGRATED KEYHEAD TRANSMITTER (IKT) KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT . CLEAR the DTCs. CYCLE the ignition. REPEAT the self-test. |
| U0100 | Lost Communication With ECM /PCM |
NOTE:
If DTCs U0100 and U2510 are both present, address DTC U2510 first. GO to PINPOINT TEST G . |
| U2510 | CAN - Invalid Data for Vehicle Security | CARRY OUT a parameter reset of the IC and the PCM and CYCLE the ignition 3-5 times, making an attempt to start the vehicle each key cycle. REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET . CLEAR the DTCs. CYCLE the ignition. REPEAT the self-test. |
| U2511 | CAN - Data Mis-Match (Receive Data Does Not Match Expected) |
NOTE:
If DTCs U2510 and U2511 are both present, address DTC U2510 first. GO to PINPOINT TEST G . |
| All other DTCs | - | REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES . |