Ignition Lock Cylinder - Non Functional: Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Rotate the ignition switch and the new ignition lock cylinder so the that the d-slot in the ignition lock cylinder lines up with the d-slot in the lock cylinder housing (ignition switch and lock cylinder must be in the ACC position).
- Insert the ignition lock cylinder into the lock cylinder housing until the retention pin engages into the lock cylinder housing.
- Verify proper installation by rotating the key through all positions and pulling back out on the key to make sure the lock cylinder does not pull out.
- Install the PATS transceiver. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .