Ignition Lock Cylinder - Functional: Removal
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Individual lock cylinders are repaired by discarding the inoperative cylinder and rebuilding a new lock cylinder using the appropriate lock repair package. The lock repair package includes a detailed instruction sheet to build the new lock to match the key cut pattern for the vehicle, thus allowing for single point replacement without needing to replace or reprogram other locks or keys.
NOTE:
If a new keys are required, the new Passive Anti-Theft System (PATS) keys must be programmed. For additional information, refer to Integrated Keyhead Transmitter (IKT) Key Programming Using Diagnostic Equipment in
ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS
.
- Remove the PATS transceiver. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
- Turn the ignition key to the ACC position.
- Using a suitable tool (such as a pin punch), press the ignition lock cylinder retention pin (while pulling on the key) and remove the ignition lock cylinder.