LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2005 (Engine Controls - Electronic Engine Controls) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower intake manifold. For additional information, refer to ENGINE - 3.5L .
  2. Disconnect the Cylinder Head Temperature (CHT) sensor electrical connector.
  3. Remove and discard the CHT  sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
    • Do not reuse the CHT  sensor, install a new sensor.
scientia non olet · About LEMON Manuals