Removal and Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
- Remove the LH catalytic converter. For additional information, refer to EXHAUST SYSTEM .
- Remove the bolt, nut and the heat shield.
- To install, tighten to 10 Nm (89 lb-in).
- Remove the rubber grommet cover.
- Disconnect the Crankshaft Position (CKP) sensor electrical connector.
- Remove the bolt and the CKP
sensor.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.