LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2005 (Engine Controls - Electronic Engine Controls) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

RH sensor 

  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .

    LH sensor 

  2. Remove the ACL assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .

    Both sensors 

  3. Disconnect the Camshaft Position (CMP) electrical connector.
  4. Remove the bolt and the CMP  sensor.
    • To install, tighten to 10 Nm (89 lb-in).
    5. NOTE: Lubricate the CMP  O-ring seal with clean engine oil.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals