LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2004 (Information System And Entertainment System) >> Removal And Installation >> Antenna Cable - Satellite Radio, With Navigation >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The satellite radio antenna cable is part of the electrical harness. The cable is only serviceable by overlaying a new component and securing it to the electrical harness. Cut the ends off the existing cable and secure them with tape to prevent NVH concerns.
NOTE: A splitter is built-in to the front satellite radio antenna cable to split the satellite radio and Global Positioning System (GPS) signals. The splitter is only serviceable by cutting the existing splitter out and overlaying a new component on the wiring harness. Secure the new splitter to prevent NVH concerns.
  1. Cut the ends from the existing component and tape them back.
  2. Overlay the new component on the wiring harness and secure it as necessary.
scientia non olet · About LEMON Manuals