LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2004 (Information System And Entertainment System) >> Removal And Installation >> Antenna Cable - AM/FM >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Lower antenna cable 

  1. Remove the Audio Control Module (ACM). For additional information, refer to AUDIO CONTROL MODULE (ACM)  .

    Upper antenna cable 

  2. Remove the RH A-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Remove the front interior lamp. For additional information, refer to INTERIOR LIGHTING .
  4. Loosen the AM/FM antenna base bolt and disconnect the antenna cable from the antenna.
    • To install, tighten to 7 Nm (62 lb-in).
  5. Remove the RH sun visor. For additional information, refer to Headliner in INTERIOR TRIM AND ORNAMENTATION .
    6. NOTE: Lower the headliner, as necessary.
  6. Remove the AM/FM antenna cable bolt and the antenna cable.
    • To install, tighten the bolt to 12 Nm (106 lb-in).

    Both antenna cables 

  7. Remove the RH front door scuff plate. For additional information, refer to Interior Trim - Exploded View in INTERIOR TRIM AND ORNAMENTATION .
  8. Disconnect the upper antenna cable from the lower antenna cable.
  9. Release the pin-type retainers and remove the antenna cable.
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals