LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2003 (Wiper System & Washer System) >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
  2. Disconnect the windshield wiper motor electrical connector.
  3. Remove the 2 windshield wiper mounting arm and pivot shaft assembly bolts and the windshield wiper mounting arm and pivot shaft assembly.
    • To install, tighten to 7 Nm (62 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals