LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1999 (Power Steering System) >> Removal And Installation >> Power Steering Fluid Cooler >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.
  1. Using a suitable suction device, remove the power steering fluid from the reservoir.
  2. Remove the front bumper cover. For additional information, refer to BUMPERS .
  3. Release the clamps and disconnect the 2 return hoses from the power steering fluid cooler.
  4. Remove the power steering fluid cooler-to-subframe bolt.
    • To install, tighten to 9 Nm (80 lb-in).
  5. Remove the 2 power steering fluid cooler nuts.
    • To install, tighten to 7 Nm (62 lb-in).
  6. To install, reverse the removal procedure.
  7. Fill the power steering system. For additional information, refer to STEERING SYSTEM .
scientia non olet · About LEMON Manuals