LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1997 (Charging System (Battery, Mounting And Cables)) >> Removal And Installation >> Battery Cables >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery tray. For additional information, refer to BATTERY TRAY .
  2. Remove the nut and position the battery cable body ground terminal aside.
    • To install, tighten to 9 Nm (80 lb-in).
  3. Remove the nut and position the Battery Junction Box (BJB) cable terminal aside.
    • To install, tighten to 9 Nm (80 lb-in).
  4. Remove the starter solenoid terminal cover.
  5. Remove the nut and position the battery cable starter solenoid terminal aside.
    • To install, tighten to 12 Nm (106 lb-in).
  6. Remove the nut and position the battery cable starter motor terminal aside.
    • To install, tighten to 12 Nm (106 lb-in).
  7. Release the battery cable locator from the engine.
  8. Remove the bolt and position the battery cable engine ground terminal aside.
    • To install, tighten to 12 Nm (106 lb-in).
  9. Release the battery cable from the top of the intake manifold.
  10. Release the 3 battery cable locators from the LH valve cover.
  11. Position the generator B+ terminal protective cover aside, remove the nut and position the generator B+ terminal aside.
    • To install, tighten to 17 Nm (150 lb-in).
  12. Remove the battery cables.
  13. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals