Seat Track: Removal
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.
NOTE:
The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE:
To install a new Occupant Classification System Module (OCSM) or an Occupant Classification Sensor (OCS) weight sensor bolt, refer to the appropriate procedure in
REMOVAL AND INSTALLATION
.
All seats
- Remove the front seat backrest. For additional information, refer to SEAT BACKREST - FRONT .
- Separate the seat wire harness main feed electrical connector(s) from the seat track brackets.
- Disconnect the safety belt buckle switch electrical connector. Separate any retainers holding the wire harness or electrical connector to the seat track.
- For power seat, disconnect all the seat track motor electrical connectors and separate any retainers holding the wire harness or electrical connectors to the seat track.
Driver seat
- Disconnect the seat track position sensor and separate any retainers holding the wire harness or electrical connectors to the seat track.
- If equipped, disconnect the Driver Seat Module (DSM) electrical connectors and separate any retainers holding the wire harness to the seat track.
Passenger seat
- For manual seat, separate the wire harness from the OCS weight sensor bolt protection brackets, remove the 4 OCS weight sensor bolt protection bracket screws and remove the 4 OCS weight sensor bolt protection brackets.
- For power seat, remove the inboard and outboard OCS
weight sensor bolt protection brackets.
- Separate the wire harness from the outboard OCS weight sensor bolt protection bracket, remove the 2 outboard OCS weight sensor bolt protection bracket screws and remove the outboard OCS weight sensor bolt protection bracket.
- Separate the wire harness from the inboard OCS weight sensor bolt protection bracket, remove the inboard OCS weight sensor bolt protection bracket screw and the inboard OCS weight sensor bolt protection bracket.
- Mark the 4 OCS weight sensor bolt electrical connectors so that they can be reconnected in their same location at installation.
- Disconnect the 4 OCS weight sensor bolt electrical connectors and detach any wire harness retainers to the seat track.
- Disconnect the OCSM and detach any wire harness retainers to the seat track.
- If equipped, disconnect the heated seat module electrical connector and detach any wire harness retainers to the seat track.
- If equipped, disconnect the Dual Climate Controlled Seat Module (DCSM) electrical connectors and detach any wire harness retainers to the seat track.
All seats
- Separate any retainers holding the seat wire harness or electrical connectors to the seat track.
- Remove the 4 seat track-to-cushion frame bolts and remove the seat track.
NOTE:
Rear inboard OCS
weight sensor bolt protection bracket shown, others similar.