Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

NOTE: The cushion Thermo-Electric Device (TED) filter is detachable from the TED assembly housing from underneath the seat cushion.

Remove the front seat cushion. For additional information, refer to SEAT CUSHION - FRONT .
Release the cushion trim cover retainers from the cushion frame and remove the cushion trim cover and cushion foam pad.
Remove the 3 cushion TED -to-cushion frame screws.
Remove the cushion TED -to-climate control seat cushion adapter screw and remove the TED .
To install, reverse the removal procedure.
- For correct front passenger seat cushion wire harness routing, refer to SEAT WIRE HARNESS ROUTING - FRONT PASSENGER CUSHION .