LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1995 (Seat System - Seats) >> Removal And Installation >> Seat Cushion - Rear, 40 Percent >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 40 percent seat. For additional information, refer to SEAT - REAR, 40 PERCENT .
  2. If equipped, disconnect the backrest heater mat electrical connector and separate the 2 heated seat electrical connectors from the backrest assembly.
  3. Release the tab and remove the outboard cushion frame pivot bracket cover.
  4. Release the tab and remove the inboard cushion frame pivot bracket cover.
  5. Remove the 2 cushion frame pivot bracket bolts and the cushion assembly.
    • To install, tighten to 25 Nm (18 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals