Seat Cushion - Front: Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- For seat with fold-flat backrest, make sure the fold-flat recliner cable is routed correctly between the power seat track cross tube and cushion frame.
- Position the cushion assembly and install the 4 cushion frame-to-seat track bolts.
- For power seat track, make sure the cushion frame-to-seat track rear brackets are aligned correctly with the tabs seated in the cushion frame.
- Tighten to 23 Nm (17 lb-ft).
- For correct front passenger seat cushion wire harness routing, refer to SEAT WIRE HARNESS ROUTING - FRONT PASSENGER CUSHION .
- For seat with fold-flat backrest, attach the 2 fold-flat recliner cable holders to the bottom of the cushion frame.
- Connect the heated seat module 2 heater mat electrical connectors.
- Route the wiring harnesses and attach the pin-type retainers to the cushion frame.
- If equipped, connect the cushion TED electrical connector.
- Attach any remaining wire harness and connector retainers to the cushion frame.
- Install the front seat. For additional information, refer to SEAT - FRONT .