LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1995 (Seat System - Seats) >> Removal And Installation >> Seat Control Switch - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

All seats 

  1. If possible, position the seat all the way up and center the seat in the front door opening.
  2. Depower the SRS  . For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
  3. Separate the safety belt retractor belt anchor from the seat in the following sequence.
    1. Carefully pull up and out to remove the safety belt retractor belt anchor nut cover from the cushion side shield.
    2. Remove the safety belt anchor nut.
      • To install, tighten to 47 Nm (35 lb-ft).
    3. Separate the safety belt retractor belt anchor from the seat.
  4. Remove the seat control switch in the following sequence.
    1. Pull out and remove the seat control switch knob(s).
    2. If equipped with manual recline, release the clip and remove the manual recline handle.
    3. If equipped with manual lumbar, pull and remove the manual lumbar handle.
    4. Remove the cushion side shield screw(s).
    5. Slide the cushion side shield up in the rear to release the retainer.
    6. Slide the cushion side shield forward to disengage the retainer.
    7. Release the cushion side shield clips and separate the seat control switch.
    8. Disconnect the seat control switch electrical connector and remove the switch.
  5. To install, reverse the removal procedure.
  6. Repower the SRS  . If a passenger seat has been serviced, do not prove out the SRS at this time  . For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .

    Passenger seat 

  7. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test. For additional information, refer to GENERAL PROCEDURES .
scientia non olet · About LEMON Manuals