LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1995 (Seat System - Seats) >> Removal And Installation >> Power-Fold Seat Motor - Rear Seat >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat. For additional information, refer to SEAT - REAR, 40 PERCENT  or SEAT - REAR, 60 PERCENT .
  2. Remove 2 screws and the outboard lower side shield.
  3. Remove the power fold motor in the following sequence.
    1. Remove the 2 screws from the power fold motor.
    2. Slide the cable housing out of the recliner.
    3. Turn the cable end so the tab aligns with the slot in the lever and separate the cable.
    4. Remove the power fold motor.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals