Removal and Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing a new Dual Climate Controlled Seat Module (DCSM), it is necessary to carry out Programmable Module Installation (PMI). For additional information, refer to
MODULE CONFIGURATION
.
NOTE:
The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE:
The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
- Before removing the DCSM , carry out the appropriate steps in the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
- Remove the front passenger seat. For additional information, refer to SEAT - FRONT .
- Remove the DCSM
.
- Disconnect the 3 electrical connectors.
- Remove the 2 screws.
- Remove the DCSM .
- To install, reverse the removal procedure.
- Install the front passenger seat. For additional information, refer to SEAT - FRONT .
- Install the DCSM software data. Carry out the appropriate steps in the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .