LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1995 (Seat System - Seats) >> Diagnosis And Testing >> Seats >> Principles of Operation >> Setting the Soft Stop

Setting the Soft Stop

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If a new DSM  or driver seat track has been installed, all driver seat track soft stops must be reset.

Use the following procedure once a new seat track or DSM  has been installed.

During the setting procedure, if the seat track stops before the end of travel has been reached, the DSM  has stopped at a previously set soft stop. To set the new soft stop, release the seat control switch and press again in the same direction until the seat track stops.

  1. Turn the ignition to the ON position.
  2. Press the seat control switch horizontal button forward until the seat track stops.
  3. Keep the horizontal button pressed forward for one second after the seat track reaches its forward end of travel. The horizontal forward soft stop has been set, release the switch button.
  4. Repeat Steps  2 and  3 for all seat track axis in both directions.
scientia non olet · About LEMON Manuals