Heated Seats - Front

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Never install heated seat parts not intended for use on this vehicle. Parts released for other model years or vehicle lines are not compatible even if they appear visually and physically similar. Installing incorrect parts will result in heated seat system performance outside design specification. Failure to follow this instruction may result in serious personal injury.

Vehicles equipped with front heated seats are equipped with a single-heated seat module to control both front heated seats. The heated seat module is located under the front passenger seat. The HVAC module includes both driver and passenger heated seat control buttons and indicators. The heated seat system will function independently of the vehicle's climate control system. A momentary ground signal is transmitted to the heated seat module when a heated seat switch button on the HVAC module is depressed and ignition switched voltage is supplied. Upon receiving each control signal to an input circuit, the heated seat module will decrease one setting (the sequence is hi, low, OFF, hi, etc.). When a heated seat is set to hi, both LED indicators above that heated seat's control button will illuminate. When a heated seat is set to low, only one LED indicator above that switch will illuminate. When activated, the heated seat module supplies voltage to the selected seat's heater circuit. Each seat's cushion heater mat and backrest heater mat is connected in a series circuit to the heated seat module and powered by the output circuit for that seat and ground. The heated seat module monitors inputs from a temperature sensor, located in each seat's cushion heater mat and maintains seat temperature by regulating current flow to the heater circuits. The heated seat module will remain ON until the heated seat switch button is depressed to cycle the heated seat module OFF or the ignition switch is set to OFF.

If a fault is detected by the heated seat module, the module will stop supplying voltage to that individual left or right seat and switch indicator, that the fault was detected on. The faults detected will be: a heater supply circuit short to battery, ground or open; sensor circuit short to battery or open; heated seat switch stuck closed to ground. To reset the module, cycle the ignition switch OFF and then ON. After the heated seat module has been reset, the module will return to an OFF state. The heated seat module does not report DTCs and does not communicate on any of the CAN .