Rear Disc Brake: Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Using specified brake parts cleaner, clean and dry the brake disc-to-hub mounting surface, then apply a thin coat of the specified anti-seize lubricant where indicated.

Fig 1: Locating Anti-Seize Lubricant Applying Areas On Brake Disc
Courtesy of FORD MOTOR CO.
Install the brake disc onto the wheel hub.
Position the brake caliper and anchor plate assembly and install the 2 brake caliper anchor plate bolts.
- Tighten to 90 Nm (66 lb-ft).
Install the wheel and tire. For additional information, refer to WHEELS AND TIRES .
- Apply brakes several times to verify correct brake operation.