LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1992 (Rear Disc Brake System) >> Removal And Installation >> Rear Brake Caliper Support Plate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake disc shield. For additional information, refer to BRAKE DISC SHIELD .
  2. Remove the 2 parking brake cable-to-support plate bolts, disconnect the parking brake cable from the lever and position the cable aside.
    • To install, tighten to 23 Nm (17 lb-ft).
  3. Remove the 2 dust boot shield bolts and the dust shield.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Remove the dust boot.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals