Removal and Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES .
- Disconnect the wheel speed sensor electrical connector.
- Disconnect the wheel speed sensor harness from the brackets.
- Disconnect the pushpin fasteners.
- Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
NOTE:
It is not necessary to remove the harness routing brackets.