LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1991 (Anti-Lock Brake System - Vehicle Dynamic Systems) >> Removal And Installation >> Hydraulic Control Unit (HCU) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
  1. Remove the Air Cleaner (ACL) outlet tube and the ACL  assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  2. Remove the battery and battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Disconnect the ABS module electrical connector.
  4. Disconnect the 6 brake tube fittings.
    • To install, tighten the brake master cylinder tube fittings to 27 Nm (20 lb-ft).
    • To install, tighten the remaining brake tube fittings to 22 Nm (16 lb-ft).
  5. Remove the 3 Hydraulic Control Unit (HCU) bracket-to-frame bolts and the HCU  .
    • To install, tighten to 25 Nm (18 lb-ft).
  6. Remove the 3 HCU  bracket-to- HCU  bolts and separate the HCU  from the bracket.
    • To install, tighten to 15 Nm (133 lb-in).
    7. NOTE: Make sure the HCU  and ABS module are clean and free of any brake fluid or foreign material before separating the components.
  7. To install, reverse the removal procedure.
    • Bleed the brake system. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION .
    • Carry out the IVD Initialization sequence. Follow the scan tool directions.
scientia non olet · About LEMON Manuals