Normal Operation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The ABS module utilizes battery voltage from Battery Junction Box (BJB) fuse 57 (40A) along circuit SBB57 (WH/RD) and ground along GD121 (BK/YE) to operate the inlet and outlet valve coils.

The operating voltage required to operate the valve coils is between 10 and 16 volts. If the voltage is above or below the required operating voltage, multiple valve coil circuit fault DTCs will set.

The valve coils and circuitry are internal to the ABS module and cannot be serviced separately.

DTC DESCRIPTION AND FAULT TRIGGER CONDITIONS

DTC Description	Fault Trigger Conditions
C1194 ABS Outlet Valve Coil LF Circuit Failure C1198 ABS Inlet Valve Coil LF Circuit Failure C1210 ABS Outlet Valve Coil RF Circuit Failure C1214 ABS Inlet Valve Coil RF Circuit Failure C1242 ABS Outlet Valve Coil LR Circuit Failure C1246 ABS Outlet Valve Coil RR Circuit Failure C1250 ABS Inlet Valve Coil LR Circuit Failure C1254 ABS Inlet Valve Coil RR Circuit Failure C1404 Traction Control Valve Rear Circuit Failure C1410 Traction Control Valve LF Circuit Failure C1957 Dynamic Stability Control Valve RF Circuit Failure C1958 Dynamic Stability Control Valve LF Circuit Failure	If, during normal operation or the on-demand self test, the ABS module detects an open circuit, short to ground or battery or a defective trigger circuit for a valve coil, the appropriate DTC will be set. Also, if charging system voltage is above 16 volts or below 10 volts, multiple valve coil circuit DTCs will set.

DTC Description

Fault Trigger Conditions

C1194 ABS Outlet Valve Coil LF Circuit Failure
C1198 ABS Inlet Valve Coil LF Circuit Failure
C1210 ABS Outlet Valve Coil RF Circuit Failure
C1214 ABS Inlet Valve Coil RF Circuit Failure
C1242 ABS Outlet Valve Coil LR Circuit Failure
C1246 ABS Outlet Valve Coil RR Circuit Failure
C1250 ABS Inlet Valve Coil LR Circuit Failure
C1254 ABS Inlet Valve Coil RR Circuit Failure
C1404 Traction Control Valve Rear Circuit Failure
C1410 Traction Control Valve LF Circuit Failure
C1957 Dynamic Stability Control Valve RF Circuit Failure
C1958 Dynamic Stability Control Valve LF Circuit Failure

If, during normal operation or the on-demand self test, the ABS module detects an open circuit, short to ground or battery or a defective trigger circuit for a valve coil, the appropriate DTC will be set. Also, if charging system voltage is above 16 volts or below 10 volts, multiple valve coil circuit DTCs will set.

This pinpoint test is intended to diagnose the following:

Wiring, terminals or connectors
ABS module