LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1990 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper Anchor Plate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES .
    2. NOTE: Do not pry in the caliper sight hole to retract the pistons as this can damage the pistons and boots.
    NOTE: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
  2. Remove the 2 brake caliper guide pin bolts and position the caliper aside.
    • Support the caliper using mechanic's wire.
    • To install, tighten to 88 Nm (65 lb-ft).
  3. Remove the brake pads and the stainless steel shims.
  4. Remove the brake pad slides.
  5. Remove the 2 brake caliper anchor plate bolts and the anchor plate.
    • To install, tighten the new bolts to 133 Nm (98 lb-ft).
  6. To install, reverse the removal procedure.
    • Apply brakes several times to verify correct brake operation.
scientia non olet · About LEMON Manuals