LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1988 (Front Drive HALFSHAFTS) >> Removal And Installation >> Intermediate Shaft - Front Wheel Drive (FWD) >> Removal

Intermediate Shaft - Front Wheel Drive (FWD): Removal

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH halfshaft. For additional information, refer to HALFSHAFT - RH .
  2. Remove the 2 catalytic converter support bracket bolts.
    Fig 1: Locating Catalytic Converter Support Bracket Bolts
    G06269872Courtesy of FORD MOTOR CO.
  3. Remove the 2 intermediate shaft bracket-to-block stud bolts.
  4. Remove the intermediate shaft bracket-to-block bolt.
  5. Carefully remove the intermediate shaft while supporting both ends of the intermediate shaft.
    Fig 2: Removing Intermediate Shaft
    G06500738Courtesy of FORD MOTOR CO.
  6. Remove and discard the circlip from the outboard end of the intermediate shaft.
    Fig 3: Locating Circlip On Outboard End Of Intermediate Shaft
    G06125776Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals