LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1988 (Front Drive HALFSHAFTS) >> Removal And Installation >> Intermediate Shaft - All Wheel Drive (AWD) >> Removal

Intermediate Shaft - All Wheel Drive (AWD): Removal

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The intermediate shaft seal in the Power Transfer Unit (PTU) must be replaced whenever the intermediate shaft is removed. For additional information, refer to TRANSFER CASE - POWER TRANSFER UNIT (PTU) .
  1. Remove the right halfshaft assembly. For additional information, refer to HALFSHAFT - RH .
  2. Remove the 2 intermediate shaft support bracket bolts and the intermediate shaft.
  3. Remove and discard the circlip from the outboard end of the intermediate shaft.
    Fig 1: Locating Circlip On Outboard End Of Intermediate Shaft
    G06125776Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals