LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1987 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Removal

Stub Shaft Seal: Removal

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Rear Drive Unit (RDU) does not have stub shaft pilot bearings. It has stub shaft seals only.
  1. Remove the halfshaft. For additional information, refer to REAR DRIVE HALFSHAFTS .
  2. Using the Torque Converter Fluid Seal Remover and Slide Hammer, remove the stub shaft seal.
    Fig 1: Removing Stub Shaft Seal Using Torque Converter Fluid Seal Remover And Slide Hammer
    G06065011Courtesy of FORD MOTOR CO.