LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1987 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Installation

Stub Shaft Seal: Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the new stub shaft seal with grease.
    Fig 1: Identifying Front Axle Oil Seal Installer And Handle
    G06065012Courtesy of FORD MOTOR CO.
  1. Using the Front Axle Oil Seal Installer and Adapter Handle, install the stub shaft pilot bearing housing seal.
  2. Install the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS .
scientia non olet · About LEMON Manuals