Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that the mating surface is clean before installing the new seal.

Fig 1: Identifying Pinion Sealer Replacer

Courtesy of FORD MOTOR CO.

Using the Pinion Seal Replacer, install the drive pinion seal.

NOTE: Lubricate the pinion flange splines with grease.

Fig 2: Identifying Index-Mark On Pinion Flange To Yoke

Courtesy of FORD MOTOR CO.

Line up the index marks and position the pinion flange.
Using the Drive Pinion Flange Holding Fixture, install the new pinion flange nut.
- Tighten to 244 Nm (180 lb-ft).
  
  Fig 3: Identifying Drive Pinion Flange Holder Fixture
  Courtesy of FORD MOTOR CO.
Install the driveshaft. For additional information, refer to DRIVESHAFT .