LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1984 (Transfer Case - Four Wheel Drive (4WD) Systems) >> Removal And Installation >> 4X4 Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. From below the RH side instrument panel, remove the hush panel.
  2. Disconnect the 4X4 control module harness connector.
  3. Remove the 4X4 control module nut.
    • To install, tighten to 7 Nm (62 lb-in).
  4. Remove the 4X4 control module and bracket.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals