Removal and Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the upper steering column shroud.
- Release the tilt lever, remove the 3 lower steering column shroud screws and the shroud.
- Disconnect the multifunction switch electrical connector.
- Remove the 2 multifunction switch screws and remove the switch.
- To install, reverse the removal procedure.
NOTE:
Release the upper steering column shroud by pressing inward on the sides of the shroud and lifting upwards.