LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1981 (Exterior Lighting System) >> Removal And Installation >> Rear Lamp Assembly - Liftgate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Disconnect the liftgate lamp electrical connector.
  3. Remove the 8 nuts and the liftgate lamp.
    • To install, tighten to 6 Nm (53 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals