LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1981 (Exterior Lighting System) >> Removal And Installation >> Headlamp Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Edge or MKX 

  1. Remove the instrument panel side finish panel.

    Edge 

  2. NOTE: The headlamp switch is removed by pushing from behind.
  3. Release the 2 tabs and remove the headlamp switch.
    • Disconnect the electrical connector.

    MKX 

  4. NOTE: The headlamp switch and bezel assembly is removed by pushing from behind.
  5. Release the tabs and remove the headlamp switch and bezel assembly.
    • Disconnect the electrical connectors.
  6. Release the 2 tabs and remove the headlamp switch.

    All vehicles 

  7. To install, reverse the removal procedure.