Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
Remove the 2 screws and position the fender splash shield aside.

Fig 1: Locating Fender Splash Shield And Screws
Courtesy of FORD MOTOR CO.
Release the tabs and remove the fog lamp bezel.
Release the locking tabs and remove the fog lamp.
- Disconnect the electrical connector.
To install, reverse the removal procedure.