LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1981 (Exterior Lighting System) >> Diagnosis And Testing >> Turn Signal and Hazard Lamps >> Principles of Operation >> Notes

Principles of Operation: Notes

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Smart Junction Box (SJB) is also known as the Generic Electronic Module (GEM).

The SJB  monitors the multifunction switch position by sending multiple voltage signals to the multifunction switch. When the multifunction switch is in the LH or RH TURN position, or the hazard lamp switch is pressed, that input signal is routed to ground.

When the SJB  receives a request for a turn signal or hazard lamps, the SJB  supplies voltage to the appropriate turn lamps.

The timed on/off cycle is determined by the SJB  and is set to flash approximately 80 times per minute if both the front and rear turn lamps operate correctly. If an individual turn signal lamp is inoperative, the SJB  flashes the remaining turn lamp approximately 160 times per minute.

The timed on/off cycle for the hazard lamps is set to flash approximately 80 times per minute.