LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1979 (MULTIFUNCTION Electronic Modules) >> Diagnosis And Testing >> Driver Seat Module (DSM) >> Pinpoint Tests >> Pinpoint Test B: DTC B1317 >> Pinpoint Test B: DTC B1317

Pinpoint Test B: DTC B1317

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: DTC B1317 may be stored in the module memory due to previous battery charging or vehicle jump starting events.
  1. B1 CHECK FOR DTC B1317, B1676 OR P0563 SET IN OTHER MODULES 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: (All Modules) Self-Test.
    • Retrieve the continuous memory DTCs from all modules.
    • Is DTC B1317, B1676 or P0563 (PCM) set in more than one module? 
    • Yes:  REFER to CHARGING SYSTEM to diagnose an overcharging condition.
    • No:  GO to B2  .
  2. B2 CHECK THE BATTERY VOLTAGE 
    • Turn off all interior/exterior lights and accessories.
    • Start and run the engine at approximately 2,000 rpm for 3 minutes while monitoring the battery voltage.
    • Does the battery voltage rise to 15 volts or higher? 
    • Yes:  REFER to CHARGING SYSTEM to diagnose an overcharging condition.
    • No:  GO to B3  .
  3. B3 RECHECK FOR DTC B1317 
    • Turn the engine off.
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: DSM  Self-Test.
    • Clear the continuous memory DTCs.
    • Carry out the DSM  self-test.
    • Is DTC B1317 present? 
    • Yes:  INSTALL a new DSM  . REFER to DRIVER SEAT MODULE (DSM) . TEST the system for normal operation.
    • No:  The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
scientia non olet · About LEMON Manuals