Removal and Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the parking brake switch electrical connector.
- Remove the parking brake control adjustment nut.
- Remove the front parking brake cable-to-control nut and position the front cable aside.
- To install, tighten to 23 Nm (17 lb-ft).
- Remove the 3 parking brake control nuts and the parking brake control.
- To install, tighten to 23 Nm (17 lb-ft).
- To install, reverse the removal procedure.
- Adjust the parking brake cable. For additional information, refer to PARKING BRAKE CABLE ADJUSTMENT .