Removal and Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
- Relieve the tension in the parking brake cable by loosening the equalizer adjustment nut.
- Disconnect the LH parking brake cable from the equalizer.
- Squeeze the tabs and disconnect the LH parking brake cable from the bracket.
All-Wheel Drive (AWD) vehicles
- Remove the wheel speed sensor bolt and position the wheel speed sensor aside.
- To install, tighten to 7 Nm (62 lb-in).
All vehicles
- Remove the 2 parking brake cable-to-support plate bolts and disconnect the cable from the lever.
- To install, tighten to 23 Nm (17 lb-ft).
- Remove the stabilizer bar link nut and position the stabilizer bar link aside.
- To install, tighten to 35 Nm (26 lb-ft).
- Remove the parking brake cable front bracket bolt, middle bracket bolt and the parking brake cable.
- To install, tighten to 23 Nm (17 lb-ft).
- To install, reverse the removal procedure.
- Adjust the parking brake cable. For additional information, refer to PARKING BRAKE CABLE ADJUSTMENT .