LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1974 (Rear Suspension System) >> Removal And Installation >> Toe Link >> Installation

Toe Link: Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Do not tighten the bolt at this time.
  1. Position the toe link and loosely install the new toe link outboard bolt and nut.
    2. NOTE: Do not tighten the bolt at this time.
  2. Loosely install the new toe link inboard bolt and nut.
  3. Install the wheel and tire. For additional information, refer to WHEELS AND TIRES .
  4. With the weight of the vehicle on the wheel and tire, tighten the toe link outboard bolt to 175 Nm (129 lb-ft).
  5. With the weight of the vehicle on the wheel and tire, tighten the toe link inboard nut to 200 Nm (148 lb-ft).
scientia non olet · About LEMON Manuals