Wheel Bearing and Wheel Hub: Removal

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If removing the wheel hub, the wheel bearing must be replaced.

Remove the wheel knuckle. For additional information, refer to WHEEL KNUCKLE .
Using the Step Plate and a suitable press, remove the wheel hub from the wheel bearing.

Fig 1: Removing Wheel Hub From Wheel Bearing Using Step Plate (205-1117)
Courtesy of FORD MOTOR CO.

NOTE: This step may not be necessary if the inner wheel bearing race remains in the wheel knuckle after removing the wheel hub.

Fig 2: Removing Inner Wheel Bearing Race From Wheel Hub Using Pinion Bearing Cone Remover

Courtesy of FORD MOTOR CO.

Using the Pinion Bearing Cone Remover and a suitable press, remove the inner wheel bearing race from the wheel hub.
Remove the snap ring.
Using the Wheel Hub Cup Remover/Installer and a suitable press, remove the outer wheel bearing race from the wheel knuckle.

Fig 3: Identifying Wheel Hub Cub Remover/Installer
Courtesy of FORD MOTOR CO.