Removal and Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not excessively bend, twist or allow the exhaust to hang from the flexible pipe or damage to the exhaust system may occur.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
- Remove and discard the 2 exhaust flexible pipe-to-exhaust Y-pipe nuts.
- Discard the gasket.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the Torca® clamp. For additional information, refer to TORCA® CLAMP .
- Separate the exhaust flexible pipe isolator and remove the exhaust flexible pipe.
- To install, reverse the removal procedure.
- Install a new gasket and nuts.
- Start the engine and check for exhaust leaks.
NOTE:
Always install new fasteners and gaskets. Clean flange faces prior to new gasket installation to make sure of correct sealing.