LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1966 (Engine System - General Information) >> General Procedures >> Connecting Rod to Crankshaft Side Clearance >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL SPECIFICATION

G06064067Courtesy of FORD MOTOR CO.
 Feeler Gauge Set
303-D027 (D81L-4201-A) or equivalent
NOTE: Refer to the appropriate ENGINE - 3.5L for the specification.
  1. Using the Feeler Gauge Set, measure the clearance between the connecting rod and the crankshaft. Verify the measurement is within specification.
    Fig 1: Measuring Clearance Between Connecting Rod And Crankshaft
    G06064096Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals